CONTROL PANEL COOLING
FAN FILTERS
Figure 2: Control Panel Filters
Check Belt Tracking:
Each belt should lay in center of the drive and
take-up rollers. If the belt tends to drift to one
side or the other of the roller, the roller should
be adjusted. A red knobs on either side of the
roller allows the roller to be twisted (Figure 3).
The belt will tend to drift towards the side which
is loosest. Thus, pull the roller out on the side
toward which the belt is drifting, or push the
roller in on the opposite side. The belt should
never be pulled so tight that the belt cannot be
shifted on the roller by pulling it firmly with
one’s hands.
BELT TRACKING KNOBS
Figure 3: Belt Tracking
Check Bulb Status:
1)
At each drone control panel press
“Menu”
2)
Press “Factory Setup”
3)
Press “Test Bulbs”
4)
Bulb test will report “Successful” if all
bulbs are working correctly, or will
identify those bulbs that are not
working.
Replacing a Bulb:
Before replacing a bulb, it is important to
determine that the bulb is, in fact, the problem.
1)
With nothing on the belt, make sure the
lane with the suspect bulb has been
started (use “start/stop job” option on
main kiosk.
2)
On drone control panel select “Menu”.
3)
Select “Factory Setup”
4)
Select “Bulb Setup”
5)
Choose belt (zone) in question (Figure
4)
6)
Circles at the right of the image
represent bulbs in the zone. (Front bulb
is bottom circle.)
7)
Press circle corresponding to suspect
bulb. If the circle turns green, the bulb is
being commanded to turn on.
8)
Visibly inspect bulb to see if it is on or
on or not.
If the bulb is truly not coming on, it should be
replaced.
1)
Turn off machine.
2)
Turn off all disconnect switches (red
knobs on drone panels)
3)
Pull sections apart if necessary to access
bulb rack with bad bulb (Figure 5). Note
wire conduit strain while moving
sections.
4)
Pull bulb rack out.
5)
Remove guards to access bulb wire
connections.
6)
Disconnect wires to bulb.
7)
Pull wires out of bulb rack metal.
8)
Remove bulb from rack by sliding bulb
left and right. (It will probably be
necessary to use fingers to slightly
