Brother GTX-4, Service Manual

Page: 419 / 500

8-2
Error code list
Error Error message Description Remedy
1030
[Color Head Getting
Warm]
The (color) head exceeding
the warning-indicated
temperature was detected.
Wait until the head has decreased in temperature.
If the error continues to happen even when you
wait for a while, replace the head.
1031 [W Head Temp Rising]
The (white) head exceeding
the warning-indicated
temperature was detected.
1051 (No message)
The expected life of the
carriage motor has expired.
(The error message is not
displayed on the panel but is
recorded in the log.)
Replace the carriage motor.
1060 [Temp Low]
The temperature is lower than
the scope covered by its
temperature warranty for the
best print result.
Turn up the temperature of the surrounding area of
the printer.
1061 [Temp High]
The temperature level is
higher than the scope
covered by its humidity
warranty for the best print
result.
Turn down the temperature of the surrounding
area of the printer.
1064 [Humidity too Low]
The humidity is lower than the
scope covered by its humidity
warranty for the best print
result.
Turn up the humidity of the surrounding area of the
printer.
1065 [Humidity too High]
The humidity level is higher
than the scope covered by its
humidity warranty for the best
print result.
Turn down the humidity of the surrounding area of
the printer.
1070 [Battery To Be Replaced]
The time for replacement of
the lithium battery of the main
circuit board approaches.
Replace the lithium battery of the main circuit
board.
1080 [RTC Not Adjusted]
The built-in clock (real time
clock) of the main circuit
board has not been set up.
Set up the clock time.
1085 [RTC Not Adjusted]
The built-in clock (real time
clock) of the main circuit
board has not been set up.
1090 [Cap/Wiper Cleaning]
The cap/wiper needs to be
cleaned.
Use the "Maintenance Part Clean/Replace" menu
to clean the cap/wiper.
1091 [Cap/Wiper Cleaning]
The cap/wiper needs to be
immediately cleaned.
1092
[Wiper Cleaner Replacing
White]
The expected life of the
(white) wiper cleaner has
expired.
Use the "Maintenance Part Clean/Replace" menu
to replace the wiper cleaner on the white side.
1093
[Wiper Cleaner Replacing
White]
Due to expiration of the
expected life of the (white)
wiper cleaner, it needs to be
immediately replaced.