Brother 882-W80, Operation Manual

Page: 27 / 124

WINDING/INSTALLING THE BOBBIN
G
etting
Re
ad
y
25
1
h
Set the bobbin winding switch to the left, until it clicks
into place.
1
Bobbin winding switch

The bobbin winding window appears.
i
Press .

Bobbin winding starts. The bobbin stops rotating
when bobbin winding is completed. The bobbin
winding switch will automatically return to its
original position.

changes to while the bobbin is
winding.

You can change the winding speed by pressing
(to decrease) or (to increase) in the bobbin
winding window.
j
After bobbin winding is finished, cut the thread with
scissors and remove the bobbin.
■
Using the Spool Pin
You can use the main spool pin to wind the bobbin before
embroidering. You cannot use this spool pin to wind the
bobbin while embroidering.
a
Turn the main power to ON and open the top cover.
b
Align the groove in the bobbin with the spring on the
bobbin winder shaft, and set the bobbin on the shaft.
1
Groove in the bobbin
2
Spring on the bobbin winder shaft
c
Remove the spool cap and place the spool of thread for
the bobbin onto the spool pin.
Slide the spool onto the spool pin so that the thread
unwinds to the front from the bottom.
1
Spool pin
2
Spool cap
3
Spool of thread
4
Spool felt
d
Slide the spool cap onto the spool pin as far as possible
to the right, with the rounded side on the left.
e
While holding the thread with both hands, pass the
thread through grooves of the thread guide plate.
1
Thread guide plate
Note
• The sound of winding the bobbin with stiff thread,
such as metallic thread for quilting, may be
different from the one produced when winding
normal thread; however, this is not a sign of a
malfunction.
Memo
• Press to minimize the bobbin winding
window. Then, you can perform other operations,
such as selecting a pattern or adjusting the thread
tension, while the bobbin is being wound.
• Press (in top right of the LCD screen) to
display the bobbin winding window again.
a
a
b
a
b
c
d
a