BONFIGLIOLI active cube 201, Operating Instructions Manual

Page: 25 / 285

12/16 Operating Instructions ACU 25
3.3 Dimensions/weight
For information on the weight and dimensions of the frequency inverter, refer to chapter 5
“Technical data”.
3.4 Transfer to place of installation
Transfer to the place of installation is done with the product in its original packaging. Frequency
inverters as from size 7 must be transferred to the place of installation in horizontal position, rear-side
down. A fork lift truck or crane with crane fork can be used for transfer to the place of installation.
 Apply the fork in the middle of the transport unit.
 Secure the transport unit to prevent it from falling down and overturning.
 Lift the transport unit up carefully.
 At the place of installation, put the transport unit down on a level and bearing surface.
3.5 Unpacking the device
 Carefully remove packaging.
 Check if the delivered devices corresponds to the order.
 Check the device for transport damage and completeness.
 Any defects/damage must be reported to the supplier immediately.
Ensure that all packaging materials are disposed of in an environmentally compatible
manner.
3.6 Bringing the device into installation position
3.6.1 Sizes 1 through 6
 Depending on the weight, one or two persons are required for lifting the device into the
installation position in the electrical cabinet. Installation, see Chapter 6 "Mechanical installation".
3.6.2 Sizes 7 and 8
 Fix two crane eyes (M8) in the marked threaded holes on the top side of the device.
 Use appropriate lifting means.