Böhnke + Partner bp308, Installation Manual

Page: 86 / 154

If you have answered »yes« to all these questions, you may switch in
the mains voltage according to the instructions in the following sec-
tion.
8.5 Switching the Mains Voltage
If you have answered »Yes« to all the questions of the »Checks
before Starting the Control Unit«, you can switch the mains voltage
in. After that, check the items of the following check-list.
Have you turned on the mains switch?
Has the emergency control unit been switched on?
Yes □
Yes □
Is the automatic circuit breaker 1F2 for the control voltage
switched on?
Is the automatic circuit breaker 1F4 for the safety voltage switched
on?
Yes □
Yes □
Have all the safety components remained inactive? Yes □
Is the voltage test module STM-02 not sending out any acoustic or
optical warning signals ?
Yes □
Does the LCD show no problem with the voltage in the bp308 sys-
tem ?
Yes □
Does the voltage in the power supply unit of bp308 between ter-
minals L and N = 230 V AC?
Yes □
Does the voltage at the terminal strip X4 between terminals 1 (LS)
and NN = 230 V AC?
Yes □
Does the voltage at terminal strip X8 from terminal 20 (A or C)
towards terminal 100 = 24 V DC?
Yes □
Does the LCD illumination fail to flash? (Would mean that system is
shut down)
Yes □
Does the colon of the LCD clock of bp308 flash? Yes □
Does the cabin light voltage at terminal strip X2 between terminal
1 and = 230 V AC an?
Yes □
Are the two LEDs for 5 V and 24 V of the power supply unit of
bp308 bright?
Yes □
Does the display of bp308 show the ERO symbol (emergency con-
trol active)?
Yes □
If you have answered »Yes« to all these questions, you can proceed
with checking the parameters of the control unit and the drive unit
8.6 Checking the Parameters of Control Unit and
Drive Unit
After having properly switched in the mains voltage and made sure
that there are no obvious faults, check the parameters set for the
control unit and the drive unit.
88
Installation Manual System »bp308« – Commissioning Instructions