Black Box ServSwitch DTX5000, User Manual

Page: 40 / 98

SERVSWITCH DTX 5000/5001/5002 USER GUIDE
28
Needed to install the DTX5001-R and DTX5002-R user stations
• Two external power supplies
• Two IEC power cords
• Applicable Quick Installation Guide
• KVM cable
• UTP cable (not supplied)
• Three-wire serial cable or null modem cable (not supplied)
Needed for non-standard installations (DTX5002-R user station
only)
To connect a VGA monitor to the user station, a DVI to VGA adaptor is required (not
supplied).
3.4 Mounting option
The user station mounts to the rear of a flat panel monitor via a mounting plate accessory.
NOTE:
Mounting accessories are ordered separately. Contact BLACK BOX for more information.
3.5 Installation options
CAUTION:
To reduce the risk of electric shock or damage to your equipment, disconnect the power from the
DTX5001-R or DTX5002-R user station by unplugging the power supply from the electrical outlet. To
reduce the risk of electric shock or damage to your equipment, turn on the remote workstation and the
DTX5001-R or DTX5002-R user station and DTX5001-T orDTX5002-T transmitter in the order described
in the following procedures.
You can install the DTX Extender System with the DTX5001-R or DTX5002-R user
station either by a point-to-point or networked configuration.
Point-to-point installation
The following instructions will enable you to install your DTX Extender System in a
point-to-point configuration. In a point-to-point configuration, no administrator setup of
the transmitter or the user station is required. This enables you to install the system
quickly, directly out-of-the-box. However, if you choose the point-to-point configuration,
you can install only one transmitter and user station pair on a subnet and must also locate
both on the same subnet as well.