Black Box ServSwitch DTX5000, User Manual

Page: 54 / 98

SERVSWITCH DTX5000/5001/5002 USER GUIDE
42
5. Confirm the HyperTerminal settings and click OK .
6. Press
Enter
to display the serial menu. The Appliance Selection Menu will be dis-
played.
Figure 4-8. Appliance Selection Menu
7. Select the Receiver or Transmitter Menu by pressing 1 or 2 and pressing Enter . You
will be prompted to enter a password.
8. Type the password and press
Enter
.
NOTE:
If there is no transmitter connected to the DTX user station, an error message will display and you will be
returned to the Appliance Selection Menu.
Navigating the serial menu
To navigate through the serial menu, type the number or letter that corresponds to the
option you wish to choose and press
Enter
. This action will bring you to a sub-menu or to
a screen where you can make configuration changes. To exit a menu or screen and to
confirm any configuration changes you have made, type
0
(zero) and press
Enter
. To
navigate back up through the menus, continue to type
0
and press
Enter
at each screen.
4.5 Configuring Network Settings
Each DTX Extender System component is shipped with default network settings
preconfigured for your DTX user station and transmitter. You can change the default
values for your system using the serial menu. If you wish, you can place the user station on
a different subnet from the transmitter.
NOTE:
IP address data can be obtained by DHCP or can be set to Static.
NOTE:
It is recommended that you configure the network settings for the transmitter before you configure the
network settings for the DTX user station.
To configure network settings for the transmitter:
1. Press
Enter
to display the serial menu. The Appliance Selection Menu displays.