Black Box ServSwitch DTX5000, User Manual

Page: 37 / 98

CHAPTER 3: INSTALLATION
25
Connecting power
The DTX5000-R user station features an external power supply. A DC power jack is
located on the rear of the DTX5000-R user station.
NOTE:
Use only the power supply provided by BLACK BOX.
To connect power to the DTX5000-R user station:
1. Plug the external power supply’s 2.5 mm connector into the DC power jack on the
rear of the DTX5000-R user station.
2. Connect the detachable IEC power cord to the power supply.
3. Plug the IEC power cord into an appropriate wall outlet.
Networked installation
The following instructions will enable you to install your DTX5000-R user station and
DTX5000-T transmitter in a networked configuration. In this installation, multiple
DTX5000-T transmitters and DTX5000-R user stations are attached via the same Ethernet
network. In this case, it is important for each unit to be configured with a unique IP
address.
NOTE:
In Desktop and Extender Modes, the DTX5000-R user station and DTX5000-T transmitter can obtain their
IP address data from a DHCP server.
DTX5000-T transmitters and DTX5000-R user stations may be configured for use on a
single subnet or for use across routers. Use of routers, however, will cause a slight
increase in end-to-end latencies, which may not be acceptable for all applications.
3 Speaker Port
4 External Power Supply
5 PS/2 Port
6 Serial Port
7 Remote Workstation
8
Local Peripherals
(attached via USB)
9 DTX5000-T transmitter
Table 3.3 Descriptions of Figure 3-3 (Continued)
Number Description