Billion 810VGTX Router
Page | 42
Failback Probe Cycle: Set the duration for the Failback Probe Cycle to determine when the router will switch back to
the main connection (main port) from the backup connection (backup port) once the main connection is communicating
again.
Note: The time set is for each probe cycle, but the decision to change to the backup port is determined by the
Probe Cycle duration multiplied by the Connection Decision amount (e.g. From the image above it will be 3
seconds multiplied by 5 consecutive fails).
Detect Rule:
Rule 1. ADSL Down
Rule 2. Ping Fail
No Ping: It will not send any ping packets to determine if the connection is active. It disables ping detection.
Ping Gateway: It will send ping packets to the gateway and wait for a response from the gateway in every
“Probe Cycle”.
Ping Host: It will send ping packets to a specific host and wait for a response in every “Probe Cycle”. The host
must be an IP address.
WAN Connection-3G Mode
In ADSL mode, as the ADSL is not available (failover/failback), it will switch to 3G mode for WAN Connection support.
However, in 3G Mode ADSL cannot support WAN Connection when 3G Mode is unavailable.
