Quick Start Guide
ConnectPort X2e Wi-Fi
Smart Energy
Power Supply
Ethernet Cable
ConnectPort X2e Wi-Fi SE
1
Verify Contents
2
Write Down the Serial Number
®
Model: ConnectPort X2e W
i-Fi SE
Part Number: 50X2E-Z1C-002-01
Serial Number: 00409D50E9BB
Model: ConnectPort X2e Wi-Fi SE
Part Number: 50X2E-Z1C-002-01
Serial Number: 00409D
50E9BB
3
Connect Hardware
Power
ZigBee
Network
(WAN)
Button
a
Connect the power supply
Write down the
ConnectPort X2e Wi-Fi SE Serial Number:
00409D:
NOTE:
The serial number
is also the Ethernet
MAC address, which
can be used to identify
the device during the
installation process.
b
a
Connect the power supply
Startup Sequence
- After connecting the power
supply, the Power LED will be solid green, the ZigBee
LED will be blinking green, and the Network LED (WAN)
will be blinking orange.
NOTE:
Once the Wi-Fi configuration is complete, the
Network (WAN) LED will change from blinking orange
to solid green.
a
4
Configure your Device Using the Wi-Fi Interface
a
c
Enable Access Point mode on your device by pressing
the button.
b
d
Configure the Wi-Fi interface of your laptop to connect to
the ConnectPort X2e gateway’s access point. The name
(SSID) of the access point will be cpx2e-se-xxxxxxxxxx,
where xxxxxxxxxxxx is the serial number of the gateway.
cc
Go to your web browser, and enter the URL of the gateway:
http://192.168.100.1
NOTE:
If the ConnectPortX2e has already been configured
to connect to an access point, it will need to be set back to
factory defaults to use the following procedure. See the
troubleshooting section below to return the gateway back
to its initial state.
Navigate to
Configuration > Wireless Wizard
.
Follow the steps in the wizard to configure your device.
e
Once the configuration is complete, your device will connect
to your home access point and attempt to connect to
Smartlee. You can track its progress by observing the network
LED behavior. Once the connection to your access point and
gateway is connected to Smartlee, all the LED’s will be solid
green.
90001281_A
