Billion 810VGTX Router
Page | 126
Trap Community: Specify a name to be identified as the Trap Community and an IP address. This community
string will be checked against the string entered in the configuration file. Once the string name is matched,
users with this IP address will be sent SNMP Traps.
SNMP V3: Specify a name and password for authentication and define the access rights from an identified IP
address. Once the authentication has succeeded, users with this IP address will be able to view and modify the
data.
SNMP Version: SNMPv2c and SNMPv3
SNMPv2c is the combination of the enhanced protocol features of SNMPv2 without the SNMPv2 security. The
“c” comes from the fact that SNMPv2c uses the SNMPv1 community string paradigm for “security”, but is
widely accepted as the SNMPv2 standard.
SNMPv3 is a strong authentication mechanism, authorization with fine granularity for remote monitoring.
Traps supported: Cold Start, Authentication Failure.
The following MIBs are supported:
From RFC 1213 (MIB-II)
System group
From RFC 1472 (PPP/Security MIB)
System group
PPP security group
Interface group
Address Translation group
From RFC 1473 (PPP/IP MIB)
IP group
PPP IP group
ICMP Group
From RFC 1474 (PPP/Bridge MIB)
TCP group
PPP Bridge group
UDP group
EGP (not applicable) Transmission
From RFC 1573 (IfMIB)
SNMP group
ifMIBObjects group
From RFC 1650 (EtherLike-MIB)
From RFC 1695 (atmMIB)
dot3stats
atmMIBObjects
From RFC 1493 (Bridge MIB)
From RFC 1907 (SNMPv2)
dot1 dBase group
only snmpSetSerialNo OID
dot1 dTp group
dot1 dStp group (if configured as
span- ning tree)
From RFC 1471 (PPP/LCP MIB)
pppLink group
pppLgr group (not applicable)
