BEST ACCESS SYSTEMS 34HW, Service Manual, Page: 129 / 228

Service and Maintenance for Cylindrical Locks
W Series Service Manual 5–19
R
EPLACING COMPONENTS FOR ELECTRIFIED CYLINDRICAL LOCKS
To replace all of the components for electrified cylindrical locks,
perform all of the tasks in the sections
Removing components for
electrified cylindrical locks and Reinstalling components for
electrified cylindrical locks .
Also use these sections to replace individual components. Use the
following table to determine which tasks to perform. For the tasks in
the column
See these tasks to remove , see the section Removing
components for electrified cylindrical locks . For the tasks in the
column See these tasks to reinstall , see the section Reinstalling
components for electrified cylindrical locks.
Removing
components for
electrified
cylindrical locks
Task A. To remove the core:
1. Insert the control key into the core and rotate the key 15 degrees to
the right.
2. Remove the core and throw member from the lever/knob.
To replace this component See these tasks to remove See these tasks to reinstall
Core Task A
(
page 5–19 )
Task D
(
page 5–24 )
Keyed lever/knob Task A through Task B1
(
page 5–19 through page 5–20 )
Task C through Task D
(
page 5–24 through page 5–24 )
Plain lever/knob Task B2
(
page 5–20 )
Task C
(
page 5–24 )
Inside rose and rose liner Task A through Task C
(
page 5–19 through page 5–21 )
Task B through Task D
(
page 5–23 through page 5–24 )
Outside rose and liner assembly Task A through Task D
(
page 5–19 through page 5–22 )
Task A through Task D
(
page 5–22 through page 5–24 )
Lock chassis Task A through Task D
(
page 5–19 through page 5–22 )
Task A through Task D
(
page 5–22 through page 5–24 )
Figure 5.22 Removing the core and throw member (lever shown)
Core
Control key
Throw member