Buttonholes
93
2022-08 EN 5020079.40A.04
9.3 Sewing a Buttonhole Automatically
> Attach the Buttonhole Foot with Slide (RJ).
> Pull out the button holder plate and insert the button.
> Pass the thread through the hole in the presser foot and then place it under the foot.
> Tap «Buttonholes».
> Select the buttonhole stitch.
> Adjust the stitch width and stitch length to the desired width and density.
> Position the fabric under the presser foot so that marking of the centerline is aligned with the starting
point (1).
> Make sure that there is no gap between the presser foot tip and the plastic part.
1
> Push the button «Start/Stop».
– While the buttonhole lever is raised, the display shows an error message to lower the buttonhole
lever.
> Pull the buttonhole lever down as far as possible until it clicks into place.
