Embroidery preparation
112
2022-08 EN 5020079.40A.04
13.2 Embroidery Foot
Attaching the Embroidery Foot
Mount the Hopper Embroidery Foot
> Raise the needle.
> Raise the presser foot and dual feed.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot holder (2) by unscrewing the presser foot bar attaching screw (1).
2
1
> Attach the Hopper embroidery Foot (JX) to the presser foot bar, making sure that the spring (3) is over
the needle clamp screw (4).
> Tighten the screw (1).
4
3
1
> After starting the machine, select the embroidery foot in the «Presser Foot Sole Display».
Note
: When using thicker materials, the Hopper Embroidery Foot (JX) may touch the edge of the embroidery
hoop. Use the Single Embroidery Foot (JL) in such cases. The needle holder can also be used with a shorter
screw, which is available together with the ruler foot.
Mount the Embroidery Foot
> Raise the needle.
> Raise the presser foot and dual feed.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot holder (2) by unscrewing the presser foot bar attaching screw (1).
2
1
