Chapter 11
Directions on Coiling, Taping and Zigzag Embroidery
The remarks of these parameters are at below:
1.
D28 Special Head Interval:
Range: 10
～
600 Default Value: 150, 162, 166, 185, 200, 216, 225, 230, 240, 250, 270, 290,
and 300
If you input the default value, there will be a “*” before the value
2.
D30 Clamp Foot Displace: 0~90
This parameter is to adjust the lifting height of clamp foot at each stitch.
3.
D40 Adj Clamp Foot Limit: 0~250
This parameter is the Max height of the clamp foot.
4.
D31 Rod Pos. of ZIG: Left/ Right
The “ROD POS. OF ZIG” determines the position of swing rod when M axis is in origin. This
parameter must be set in accordance with actual mechanical position.
5.
C38 Swing Value of ZIG
（
-10.0
～
-0.2
，
+0.2
～
+10.0
）
The parameter is for Z5 embroidery and applies to thick cords. For thick cord embroidery, at Z5
embroidery, the system moves the frame to compensate the swinging scope of the lever. The
parameter’s absolute value should be set according to the cord width. And the “+/-” is decided
by the mechanical structure. The moving directions of the lever and frame should be the same.
Otherwise please change the “+/-” setting.
6.
D42 Rotary Gap of M Axis: 0~10
The M axis of special embroidery head has mechanical gap, so it will generate the mechanical
difference after M axis changes rotating direction repeatedly. At embroidering the flat tapes, if
the shape of tape is curve and the M axis has no angle compensation, the needle will fall at the
edge of the tape instead of the right position at each turning.
Adjusting this parameter value is to ensure that the needle falls in the center of tape. During
machine debugging, parameter value should be “0” when needle falls in the center of tape. If not,
please repeat the adjustment to realize the best effect.
Generally, this parameter should be managed by professional experts before leaving factory.
BECS-D56 computerized embroidery machine owner’s manual
125
Summary of Contents for BECS-D56
Page 2: ......
