Beijing Dahao Technology BECS-D56, Owner'S Manual

Page: 25 / 188

Chapter 2 Operation Instruction
E. Pull the Bar for Embroidery
Operation bar (or embroidery bar) is installed under the table.
a. Stop Status:
Pulling the bar to right is to begin embroidery (including low and high speed idling)
Pulling the bar to left is to return (including low and high speed idling)
b. Running status:
At normal embroidery, pulling the bar to the right end is to embroider slowly and releasing the
bar will resume the normal speed.
Pulling the bar to left is to stop embroidery (including low and high speed idling).
F. Manual Operation
a. Manual Trimming
When the machine stops, click
“ ”
in the main screen. Follow the prompt and select a
trimming mode (“trim top & bot.” or “trim bottom”). Then click “ ”to trim, or click
“ ”to exit trimming operation.
b. Manual Frame-Moving
When the machine stops, press the keys
（ “ ” ）
to move the frame in the
corresponding direction. Press the next two keys at the same time to move the frame in the
direction of the angle bisector.
“ ”
is the speed key for manual frame-moving. Press
“ ”
to switch between (high speed) and (low speed).
c. Clearing the Frame Coordinates
When the machine stops, click “ ” then click “ ”to clear the XY displacements displayed
in the main screen. The function can be used with manual frame-moving.
d. Manual Color-Changing
When the machine stops, you may type in needle position number in the main screen. Then the
head will move to the corresponding needle position automatically.
e. Turn the Main Shaft to 100°Manually
Usually the main shaft is needed to stop at 100° at color-changing, frame-moving and
beginning embroidery. The user can manually turn the main shaft to 100° when it doesn’t reach
there. Click “ ” in the main screen and then choose “ ” in the followed prompt to carry
out the function.
BECS-D56 computerized embroidery machine owner’s manual 19