Basler BE1-11m, Instruction Manual

Page: 282 / 610

49-4 9424200996
Communication BE1-11 m
Note
The PC running BESTCOMS
Plus
software must be configured
correctly to communicate with the BE1-11
m
. The PC must have an IP
address in the same subnet range as the BE1-11 m if the BE1-11 m is
operating on a private, local network.
Otherwise, the PC must have a valid IP address with access to the
network and the BE1-11 m must be connected to a properly configured
router. The network settings of the PC depend on the operating
system installed. Refer to the operating system manual for
instructions.
On most Microsoft Windows based PCs, the network settings can be
accessed through the Network Connections icon located inside the
Control Panel.
8. Click the Send to Device button located on the Configure Ethernet Port screen. A confirmation pop-up
will indicate that the BE1-11 m will reboot after settings are sent. Click the Yes button to allow settings
to be sent. After the unit has rebooted and the power-up sequence is complete, the BE1-11 m is ready
to be used on a network.
9. If desired, BE1-11 m settings can be verified by selecting Download Settings and Logic from Device
from the Communication pull-down menu. Active settings will be downloaded from the BE1-11 m .
Verify that the downloaded settings match the previously sent settings.
Email Setup
The BE1-11 m is capable of sending email alerts when triggered by chosen logic. A maximum of eight
circumstances can be established for sending email alerts. Setup of email notifications is made on the
BESTCOMS
Plus
Email Setup screen (Settings Explorer, Communications, Email Setup) illustrated in
Figure 49-4. A notification is configured by entering the SMTP email server address, mail from domain,
and the email address of the intended recipients. One email address can be entered in the “To” field and
one email address can be entered in the “Cc” field. The “Subject” field accepts up to 64 characters for
describing the condition triggering the notification email.
Figure 49-4. Email Setup Screen
BESTlogic ™
Plus
Settings for Email
BESTlogic
Plus
settings are made using BESTCOMS
Plus
. To program the BESTlogic
Plus
settings, use
the Settings Explorer within BESTCOMS
Plus
to open the BESTlogic
Plus
Programmable Logic tree
branch and select the email logic block from the list of Elements . The email logic block is shown in Figure