Barco PDS, User Manual

Page: 83 / 174

PDS • User’s Guide 69
4. Operation
Setup Menu
The following functions are available:
•
Input
— selects the exact inputs that you wish to set:
ALL
(inputs
5
through
8
),
5
(individually),
6
(individually),
7
(individually), or
8
(individually).
•
Equalization
— The equalization adjustment range is from
0
(short cable
equalization) to
15
(long cable equalization). The default value is
12
, which
indicates “moderate” equalization.
In general, the default should be adequate for most users, unless cables longer
than 5M are used, and unless your signals are running at high pixel clock rates
(e.g., UXGA).
•
Set to Default
— sets the Equalization field to the default setting of 12.
•
Set to Maximum
— sets the Equalization field to the maximum setting of 15.
•
Set to Minimum
— sets the Equalization field to the minimum setting of 0.
bñÉÅìíáîÉ=jçÇÉ
From the
System Menu
, select
Executive Mode
to initiate a limited front-panel lockout.
Executive mode enables seamless transitions between input sources
without
the need to
press
TAKE
. In executive lockout mode:
• Button pushes will be ignored for all buttons
except
the nine
input buttons
and
LOGO
. All turns of the rotary knobs will be ignored.
• To take an input source to Program, press the input or
LOGO
button
without
pressing
TAKE
. The transition is seamless, even if you have
Auto Take
(in the
User Preference Menu
) turned off.
• All Ethernet and serial communications commands will function normally.
• All button lights will continue to reflect the proper state of the inputs.

Use the following steps to enable and disable executive lockout mode:
1.
From the
Setup Menu
, choose the
System Menu
.
2.
Select
Executive Mode
. The following submenu appears:
Figure 4-51.
Executive Mode Menu (sample)
Note
Inputs
5
through
8
do not need to be selected on the front
panel for this menu to change, and to apply the equalization
settings.
Note
Equalization is a subjective “visual” adjustment, which
depends on three important factors: cable length, signal
quality and cable quality. If you adjust the equalization,
optimize the setting for the lowest amount of visual artifacts.
EXECUTIVE MODE
<SEL> = Enable
<ESC> = Cancel