NEW GENERATION BUBBLE BABY SWING
• Instruction Manual
16
B. INSTRUCTIONS FOR USING THE BABY SWING
WARNING:
• Do not use the baby swing if one of the parts is broken or missing.
• Before using, check the locking mechanisms are well engaged and correctly adjusted.
• Do not lift or transport the baby swing when the baby is sitting in it.
B1. Installing the baby in the baby swing
WARNING:
always use the 5 point safety harness supplied.
IMPORTANT:
make sure the straps of the harness do not become twisted.
Place the baby in the baby swing in a sitting position or lying down. Fasten the 5 point harness.
Figures 27, 28, 29, 30 and 31
Adjust the 5 point
harness at the level of the shoulders or waist if necessary.
B2. The angle of the seat (k)
WARNING:
never change the angle of the seat when the baby is in the baby swing. Take the baby out before each manipulation.
Using both your hands grip the upper and lower parts of the seat
(k)
and adjust it depending on the position desired.
Figures 33, 34 and 35
You
can incline the base in seat or semi-recumbent position with the aid of the seat inclination controls
(r)
.
Figure 32
You can also block this position y
using the seat locking buttons
(s)
.
Figure 36
B3. Folding the baby swing and transport
Remove the early learning arch
(i)
from the baby swing.
Figure 37
Fold up the seat
(k)
: press the two folding buttons
(n)
on either side of the baby
swing while at the same time tightening the legs of the baby swing together.
Figures 38, 39, 40 and 41
Close the press stud to block the seat.
Figure 42
C. STARTING THE BABY SWING
t.
Switch to adjust the swinging
u.
Music and sound level button
v.
Timer button
w.
LEDs indicating swinging time of the baby swing
C1. Selection of swinging rate
WARNING:
do not swing the baby swing by hand: the chosen speed will set in between 20 and 45 seconds after selecting the swinging rate.
Turn the switch to set the swinging
(t)
to accelerate the swinging rate. The 1st setting - the farthest to the left – is the weakest swing, the 6th – the
farthest to the right – the strongest. To switch the swinging off turn the switch on the left.
C2. Button for choosing the music and sound level (u)
To switch the music on press the button
(u)
, once, then a 2nd, 3rd, and 4th time to raise the sound level. To switch off press the button
(u)
. a 5th
time. To change the music press the music and sound level button a 6th time.
(u)
.
C3. Timer button (v)
Use the timer to set a period of swinging.
Press the button
(v)
to choose a period of swinging of between 8, 15, or 30 minutes. The three LEDs
(w)
, beside the timer button
(v)
indicate the period
of time selected.
CARE AND MAINTENANCE
Composition
• Aluminium and PVC
• Seat: 100% polyester (suede cloth and canvass)
Care and maintenance
• Check the baby swing frequently to make sure there are no loose screws, worn out parts, torn fabric, or unstitching.
• Have the parts replaced or repaired if necessary. Only use spare parts recommended by Babymoov.
• Clean the baby swing regularly.
• The baby swing headrest and cover are surface washable. This means they can be washed with a damp cloth and soap.
• To clean the frame of the baby swing, use household soap or detergent and warm water exclusively. Do not use bleach.
• Heat or excessive exposure to the sun can cause the parts to fade or warp.
Summary of Contents for Swoon Bubble
