•
•
show ip address source command
•
•
default ip dhcp client lease command
on page 135
•
no ip dhcp client lease command
on page 135
•
show ip dhcp client lease command
on page 135
•
•
on page 136
•
on page 136
•
on page 137
ip address command
The
ip address
command sets the IP address and subnet mask for the switch or a stack,
and selects BootP or DHCP as the boot mode for the next switch reboot.
The syntax for the
ip address
command is
ip address <A.B.C.D> [netmask <A.B.C.D>] source {bootp-always|bootp-
last-address|bootp-when-needed|configured-address|dhcp-always|dhcp-
last-address|dhcp-when-needed} [stack|switch|unit]
Run the
ip address
command in Global Configuration command mode.
If the stack or switch parameter is not specified, the system automatically modifies the stack
IP address when in stack mode and modifies the switch IP address when in standalone
mode.
The following table describes the parameters for the
ip address
command.
Table 48: ip address parameters
Parameters
Description
A.B.C.D
Specifies the IP address in dotted-decimal notation.
netmask
Specifies the IP subnet mask for the stack or switch. The
netmask is optional.
source
Specifies whether to use the BootP or DHCP server to assign
an IPv4 address for the management VLAN at the next switch
reboot. Values include:
• bootp-always—always use the BootP server
• bootp-last-address—use the BootP server last used
• bootp-when-needed—use the BootP server when needed
System configuration using ACLI
132 Configuration — System
April 2011
Summary of Contents for 4524GT
