Avaya 4524GT, Configuration Manual

Page: 159 / 362

no auto-negotiation-advertisements command
The
no auto-negotiation-advertisements
command makes a port silent.
The syntax for the
no auto-negotiation-advertisements
command is
no auto-negotiation-advertisements [port <portlist>]
Run the
no auto-negotiation-advertisements
command in Interface Configuration
mode.
Connecting to Another Switch
Use ACLI to communicate with another switch while maintaining the current switch connection,
by running the
ping
and
telnet
commands.
ping command
Use the
ping
command to determine whether communication with another switch can be
established.
The ping command tests the network connection to another network device by sending an
Internet Control Message Protocol (ICMP) packet from the switch to the target device.
Important:
You must set the local IP address before you issue the ping command.
The syntax for this command is
ping <ipv6_address | dns_host_name> [datasize <64-4096>] [{count
<1-9999>} | continuous] [{timeout | -t} <1-120>] [interval <1-60>]
[debug]
Substitute
<ipv6_address | dns_host_name>
with either the IPv6 address or the DNS
host name of the unit to test.
Run this command in User EXEC command mode or any of the other command modes.
Table 71: ping parameters
Parameter Description
ipv6_address | dns_host_name IPv6 address or DNS host name of the unit to test.
datasize <64–4096> Specify the size of the ICMP packet to be sent. The
data size range is from 64 to 4096 bytes.
General switch administration using ACLI
Configuration — System April 2011 159