Avaya 4524GT, Configuration Manual

Page: 99 / 362

Variables Description
Important:
These same source IP addresses are in the IP Manager list.
For more information about the IP Manager list, see Chapter
3.
default telnet-access command
The
default telnet-access
command sets the Telnet settings to the default values.
The syntax for the
default telnet-access
command is
default telnet-access
Run the
default telnet-access
command in Global Configuration command mode.
Setting boot parameters using ACLI
The command described in this section is used to boot the switch or stack and to set boot
parameters.
boot command
The
boot
command performs a soft-boot of the switch or stack.
The syntax for the
boot
command is
boot [default] [unit <unit no>]
Run the
boot
command in Privileged EXEC command mode.
The following table describes the parameters for the
boot
command.
Table 35: boot parameters
Variables Description
default Restore switch or stack to factory-default settings after rebooting.
unit <unit no> Specify which unit of the stack is rebooted. This command is
available only in stack mode. Enter the unit number of the switch you
want to reboot.
Setting boot parameters using ACLI
Configuration — System April 2011 99