![Avaya 4524GT Configuration Manual Download Page 134](http://html1.mh-extra.com/html/avaya/4524gt/4524gt_configuration-manual_3027909134.webp)
Run the
no ip address
command in Global Configuration command mode.
The following table describes the parameters for this command.
Table 50: no ip address parameters
Parameters
Description
stack | switch
Zeroes out the stack IP address and subnet mask or the switch
IP address and subnet mask.
unit
Zeroes out the IP address for the specified unit.
Important:
When you change the IP address or subnet mask, connectivity to Telnet and the Web
Interface can be lost. Any new Telnet connection can be disabled and must connect to the
serial console port to configure a new IP address.
show ip address source command
The
show ip address source
command displays the configured boot mode for the next
switch reboot.
The syntax for the
show ip address source
command is
show ip address source
Run the
show ip address source
command in User EXEC or Privileged EXEC command
mode.
ip dhcp client lease command
The
ip dhcp client lease
command configures the DHCP client lease time in seconds,
minutes, hours, days, and weeks.
The syntax for the
ip dhcp client lease <time>
command is
ip dhcp client lease
Run the
ip dhcp client lease
command in Global Configuration command mode.
The following table describes the parameters for the
ip dhcp client lease
command.
Table 51: ip dhcp client lease parameters
Variable
Value
<time>
Specifies the DHCP client lease time. Values include:
System configuration using ACLI
134 Configuration — System
April 2011
Summary of Contents for 4524GT
