Atmel AVR AT90CAN128, Manual

Page: 147 / 428

147
7679H–CAN–08/08
AT90CAN32/64/128
14.2.1 Definitions
The following definitions are used extensively throughout the section:
14.3 Timer/Counter Clock Sources
The Timer/Counter can be clocked by an internal synchronous or an external asynchronous
clock source. The clock source is selected by the clock select logic which is controlled by the
clock select (CS22:0) bits located in the Timer/Counter control register (TCCR2).The clock
source clk
T2
is by default equal to the MCU clock, clk
I/O
. When the AS2 bit in the ASSR Register
is written to logic one, the clock source is taken from the Timer/Counter Oscillator connected to
TOSC1 and TOSC2 or directly from TOSC1. For details on asynchronous operation, see
“Asyn-
chronous Status Register – ASSR” on page 160 . For details on clock sources and prescaler, see
“Timer/Counter2 Prescaler” on page 163 .
14.4 Counter Unit
The main part of the 8-bit Timer/Counter is the programmable bi-directional counter unit. Figure
14-2 shows a block diagram of the counter and its surrounding environment.
Figure 14-2. Counter Unit Block Diagram
Figure 14-3.
Signal description (internal signals):
count Increment or decrement TCNT2 by 1.
direction Selects between increment and decrement.
clear Clear TCNT2 (set all bits to zero).
clk
T 2
Timer/Counter clock.
top Signalizes that TCNT2 has reached maximum value.
bottom Signalizes that TCNT2 has reached minimum value (zero).
BOTTOM The counter reaches the BOTTOM when it becomes zero (0x00).
MAX The counter reaches its MAXimum when it becomes 0xFF (decimal 255).
TOP The counter reaches the TOP when it becomes equal to the highest value in the
count sequence. The TOP value can be assigned to be the fixed value 0xFF
(MAX) or the value stored in the OCR2A Register. The assignment is depen-
dent on the mode of operation.
DATA BUS
TCNTn Control Logic
count
TOVn
(Int.Req.)
top bottom
direction
clear
TOSC2
T/C
Oscillator
TOSC1
Prescaler
clk
I/O
clk
Tn
clk
TnS