Artesyn BajaPPC-750, User Manual

Page: 43 / 215

2-16 BajaPPC-750: Setup
May 2002
2.4 Operational Checks
All products are tested before they are shipped from the factory. When you
receive your BajaPPC-750, follow these steps to assure yourself that the system is
operational:
1. Read “Monitor”, Chapter 10 and the operating system literature to become
familiar with their features and available tools.
2. Visually inspect the board for components that could have loosened during
shipment. Visually inspect the chassis and all cables.
3. Install the BajaPPC-750 in the VMEbus card cage. Be sure the board is seated
firmly.
4. Connect a CRT terminal to serial port A via connector P4 or the transition
module console port. Set the terminal as follows:
❑
9600 baud, full duplex
❑
Eight data bits (no parity)
❑
Two stop bits for transmit data
❑
One stop bit for receive data. If your terminal does not have separate con-
trols for transmit and receive stop bits, select one stop bit for both trans-
mit and receive. Also, be sure the serial cable is securely connected.
5. Turn the system on.
If you are using the BajaPPC-750 monitor, VxWorks, or pSOS, a sign-on mes-
sage and prompt should appear on the screen. If the prompt does not appear,
try using the toggle switch to Reset (R), then check your power supply volt-
ages and CRT cabling.
6. Turn off the power before you remove boards from the card cage.
2.5 Reset Methods
Any of the following actions reset the entire board:
• Power-up
• Input from the VMEbus SYSRESET* signal on P1 (row C, pin 12)