Artesyn BajaPPC-750, User Manual

Page: 39 / 215

2-12 BajaPPC-750: Setup
May 2002
2.2.2 Serial Numbers
Before you install the BajaPPC-750 in a card cage or system, you should record
the following information:
❑
The board serial number: _____________________________________ .
The board serial number appears on a bar code sticker located on the back of
the board.
❑
The monitor version: _________________________________________ .
The version number of the monitor is on the monitor start-up display.
❑
The operating system version and part number: ________________ .
This information is labeled on the master media supplied by Artesyn or
another vendor.
❑
The board revision number/date code: 621 _____________________ .
A sticker on the board contains the board assembly part number (beginning
with “621” for BajaPPC-750), ECO level (preceded by an asterisk *), date code,
and configuration description. Be sure to include all the information that
appears on the sticker.
❑
Any custom or user ROM installed, including version and serial number:
____________________________________________________________ .
It is useful to have these numbers available when you contact Artesyn Communi-
cation Products.
2.2.3 Connectors
The BajaPPC-750 has various connectors as follows:
P0 P0 is an optional VME connector that allows for additional I/O
and 3.3V power signals. It has six rows of 19 pins for a total of 114
extra signal paths. Pin assignments are shown in Section 6.13.
P1, P2 P1 and P2 are the main VME connectors, which are compatible
with both three-row and five-row DIN backplanes. P2 handles
PMC I/O, AUI Ethernet, and serial I/O. P2 has an optional config-
uration that includes a Motorola-specific pinout, as well as a par-
allel port. Pin assignments are shown in Section 6.13.
P3 P3 is an RJ45 connector for the front panel Fast Ethernet port.
Refer to Section 7.5.1 for the pin assignments.