AND Explosion Protected Weighing Indicator AD-4403-FP ST Series, Instruction Manual

Page: 76 / 112

9-3
Display Check Item
“Chc LEd” LEDs
Pressing [F] or [ENTER] shows a relevant number of the LED as “no.XX” and illuminates the
LED.
* To return to the check item-selecting mode, press [ESC].
LED Display
SET POINT “no. 1”
TOTAL “no. 2”
ACCEPT “no. 3”
OVER “no. 4”
UNDER “no. 5”
“Chc buZ” Buzzer
Pressing [ENTER] sounds the built-in buzzer and displays “buSy” while sounding.
* To return to the check item-selecting mode, press [ESC].
* If the buzzer has sounded continuously for 10 minutes, it returns to the check item-selecting mode
automatically.
“Chc EEP” EEPROM
Pressing [ENTER] checks the function of the EEPROM and displays “buSy” while checking.
The results of the check will be displayed later.
* The keys will not work while checking the EEPROM.
* To return to the check item-selecting mode, press [ESC].
Result of check Display
Good condition
“PASS”
Something wrong “Err”
“Chc bAt” Lithium battery
Pressing [ENTER] checks the function of the battery. The results of the check will be displayed
later.
Result of check Display
Good condition
“PASS”
Something wrong “Err”
“Chc Si” Standard serial output
Pressing [ENTER] tests the function of the standard serial output by sending
123<CR><LF>(ASCII code) at the baud rate set in the SiF-03 function setting.
“Send123” is
displayed for one second and it returns to the check item-selecting mode.
* To return to the check item-selecting mode, press [ESC].
“Chc in” Control input (Terminal #1 to #6)
Displays the status of the control input terminals, #1 to #6, on the control signal terminals, located
inside the case. “
□
” at an ON terminal is displayed at the lower position, an OFF terminal at the up
position.
*
To return to the check item-selecting mode, press [ESC].
Example: Terminal # 1,3,4,5: ON, and #2, 6: OFF