AND Explosion Protected Weighing Indicator AD-4403-FP ST Series, Instruction Manual

Page: 33 / 112

5-2
5-2 Function Settings
1. Enter the function setting mode.
Press [FUNC.] for 0.3 seconds or longer in the normal mode.
“Function” is displayed on the sub display.
* [FUNC.] will not work unless pressed for 0.3 seconds or longer.
* Press [ESC] to return to the normal mode..
2. Press a function key.
Select and press a function key from the table {5-1. General} to set or see function setting
information.
* If the wrong key pressed, press [ESC] and return to the normal.
Example: Performing basic function setting.
Press [FUNC.]. Displays show;
Main display:
“FncF-” / Sub display: “ ”
3. Input a function number.
Input a function number with the numerical keys of [0] - [9] referring to the table {Appendix C:
Function List}.
* If the wrong number selected, press [ESC] and re-input.
Press [ENTER] to enter the setting of the function number.
Press [ENTER] again. The current parameters are displayed.
Example: Performing FncF-02 setting.
Press [2] and [ENTER] in this order for the function number “02”. Displays show;
Main display:
“FncF- 2” / Sub display: “ ”
Press [ENETER] again. Displays show;
Main display:
“FncF- 2” / Sub display: “ 0” (a current value)
4. Set a parameter to the function.
Set a parameter with the numerical keys of [0] - [9] and [+/-].
* If the wrong parameter has been typed in, press [ESC] to return to the previous value. It returns to
the ready-to-input status.
Press [ENTER] to proceed. The next function number is displayed.
If more functions are to be set, set them using the procedures for step 3 and 4.
Example: Setting a parameter for FncF-02=1.
Press [1] for FncF-02=1. Displays show;
Main display:
“FncF- 2” / Sub display: “ 1” (a new value)
Press [ENTER], next number is displayed.
Main display:
“FncF- 3” / Sub display: “ ”
5. Escape from the function setting mode.
Press [FUNC.] to escape from the function setting mode. Function setting data is stored in the
EEPROM and returns to the normal mode.
* [FUNC.] will not work when a value is displayed on the sub display. In that case press [ENTER] so
that a function number is ready to be input, then press [FUNC.].