AND Explosion Protected Weighing Indicator AD-4403-FP ST Series, Instruction Manual

Page: 24 / 112

3-2
3-3 Setting and Recalling Set points
Setting set points
1. Enter the set point setting mode.
Press [CODE] [ code number (2 digits) ] [SET POINT] [ENTER] in this order. It shows;
Main display: “CodE XX”
Sub display: “YYYYYY”
Status display section (lower): “FINAL” mark turns on.
Left LEDs: “SET POINT” LED blinks.
* Use numerical keys ([0] – [9]) to type a code number.
* Set a blank for the code number with [+/-] to change the set point in use.
* Press [ESC] to return to the normal mode.
2. Select a set point.
Select a set point with [F].
3. Input a set point.
Input a set point with numerical keys ([0] – [9]) and set polarity with [+/-].
* Preset tare weight can be set up to the capacity. If exceeds, “dAtA Err” appears on the sub
display for 3 seconds. Try it again.
* Press [ESC] to cancel the input. It returns to the previous value. (While the previous value is
displayed, press [ESC] to return to the normal mode.)
* [+/-] may not work with some set points.
4. Enter the set point into memory.
Press [ENTER] to store the set point into memory.
* Settings won’t complete until [ENTER] is pressed.
Recalling set points
1. Input a code number to recall.
Press [CODE] [ code number desired (2 digits) ] [ENTER] in this order.
* Use numerical keys ([0] – [9]) to type a code number.
* Press [ESC] to cancel the input and re-input. Or erase the digits typed with [+/-] and continue
typing.
* Code numbers without the final weight setting can’t be recalled. In this case, “FinAL ” and
“not dAtA” are displayed for 3 seconds and returns to the normal mode.