Installation
24
Instruction Manual - NXA-ENET8-POE+
Connect AC Power to Power On
Prior to connecting to AC power, assure to connect the chassis ground connection to a known earth ground. Connect the power
cord to the AC socket on the switch and to a grounded, 3-pin, AC power source.
See the
section on page 28 for more information.
1.
Connect a grounding wire to the grounding terminal.
2.
Connect an external AC power source to the AC power socket of the switch using the supplied AC power cord.
Verify Switch Operation
Verify basic switch operation by checking the system LEDs.
When operating normally, the Power and Diag LED should both be on green. If either of these LEDs are on amber, see the
section on page 281 for more information.
Go to the
Understanding the System Status LEDs
section on page 34 for more information.
Make Initial Configuration Changes
At this point, you may need to make a few basic switch configuration changes before connecting to the network. You can either
connect to the switch console port or any RJ-45 port to perform this task.
Through an RJ-45 Port
The switch offers a user-friendly web-based management interface for the configuration of all the unit's features.
You can make initial configuration changes by connecting a PC directly to one of the switch's RJ-45 ports. The switch has a default
management IP address of 192.168.2.10 and a subnet mask of 255.255.255.0. You must set your PC IP address to be on the same
subnet as the switch (that is, the PC and switch addresses must both start 192.168.2.x).
Log in to the web interface using the default settings:
Login Name - admin
Password - admin
FIG. 3
Connecting AC Power
FIG. 4
System Status LEDs
External AC Power Source
Grounding wire to
the grounding terminal
System Status LEDs