Security Measures
158
Instruction Manual - NXA-ENET8-POE+
Perform these steps to configure the name and type of an ACL:
1.
Click
Security
>
ACL
.
2.
Select
Configure ACL
from the Step list.
3.
Select
Add
from the Action list.
4.
Fill in the ACL Name field, and select the ACL type.
5.
Click
Apply
.
Perform these steps to show a list of ACLs:
1.
Click
Security
>
ACL
.
2.
Select
Configure ACL
from the Step list.
3.
Select
Show
from the Action list.
Configuring a Standard IPv4 ACL
Use the Security > ACL (Configure ACL - Add Rule - IP Standard) page to configure a Standard IPv4 ACL.
The following table lists the options on this page:
FIG. 186
Creating an ACL
FIG. 187
Showing a List of ACLs
Security - ACL Options
Type
Selects the type of ACLs to show in the Name list.
Name
Shows the names of ACLs matching the selected type.
Action
An ACL can contain any combination of permit or deny rules.
Address Type
Specifies the source IP address. Use "Any" to include all possible addresses, "Host" to specify a
specific host address in the Address field, or "IP" to specify a range of addresses with the Address
and Subnet Mask fields. (Options: Any, Host, IP; Default: Any)
Source IP Address
Source IP address
Source Subnet Mask
A subnet mask containing four integers from 0 to 255, each separated by a period. The mask uses
1 bits to indicate "match" and 0 bits to indicate "ignore." The mask is bitwise ANDed with the
specified source IP address, and compared with the address for each IP packet entering the
port(s) to which this ACL has been assigned.
Time Range
Name of a time range