Settings
6. Change the angle of the times to the ground
by repositioning the bolt (Fig. 136/2)
ο
in all segments
ο
in the same hole.
Ensure that the pin (Fig. 136/2) is posi-
tioned below the carrier (Fig. 136/3) in the
adjusting segment.
Fig. 136
The deeper the pin (Fig. 136/2) is inserted in the
adjusting segment, the flatter the angle.
7. After each repositioning, secure the pin (Fig. 136/2) with safety
splint.
8. Move in the integrated running gear, i.e. lower the machine
completely.
8.7.2
Adjusting roller pressure
The roller pressure is adjusted by changing the
distance "X" (Fig. 137) on all segments with the
screw (Fig. 137/1).
1. Set the machine on the field to its working
position.
2. Apply the tractor parking brake, switch off
the tractor engine and remove the ignition
key.
3. Release the two lock nuts (Fig. 137/2).
Fig. 137
4. Set the required distance "X".
Increase roller pressure: Increase distance "X"
Reduce roller pressure: Reduce distance "X"
5. Firmly tighten counter nuts (Fig. 137/2).
6. Apply the same setting to all segments.
7. Check the work results.
The maximum roller pressure of 35 kg per roll in working position
must not be exceeded.
130
Cirrus BAH0049-1 09.14
