Alpinestars Tech-Air, User Manual

Page: 27 / 210

Fault Conditions
18-8 Maintenance, Servicing and Disposal
See section 15.
18-9 Actions in the Event of an Accident
See section 16.
19. Troubleshooting
20. Index of Error Codes
Where ‘Red LED’ is crossed marked with an “X”, the error number will correspond directly to
the number of blinks of the Red LED.
21. Tech-Air™ Support
In case of questions or if customers need further information, they may first contact the
Tech-Air™ dealer where the product was purchased, however support is also available direct
from Alpinestars:
E-mail: techairsupport@alpinestars.com
Tel: +39 0423 5286 (asking for Tech-Air™ Support)
Tip: Remember that a full list of Tech-Air™ dealers in your country is available
from the Tech-Air™ Data Portal.
Problem Possible Cause Possible Solutions
Vest does not startup when the
activation flaps (18) are closed.
Master Switch not on Turn on Master Switch (8)
Battery fully discharged Recharge battery (Section 11)
Suit and vest not connected Connect LED Display wires to unit (section 8)
Activation flaps open Close the activation flaps, checking that as they
are closed the magnets attract one another.
Activation Flaps obstructed or not aligned Check that there is nothing in between the
activation flaps and that the velcro closure is
only used AFTER the magnets have attracted
both parts together.
Single Red Indication on LED
Display
Dependent on error Consult list of error codes in Section 20 for
recommended solution
Code Number Red LED Error Description Possible Solution
001
x
Firmware Error Reflash Firmware / Return for Service
002
x
Power Supply Error Recharge Battery / Return for Service
003
x
Battery Voltage Too Low Recharge Battery
004
x
Reset Squib Error Restart Unit, if error persists, Return for Service
005
x
Squib Configuration Error Recharge Battery, Restart Unit, if error persits, Return Service
006
x
Squib Diagnosis Fail Restart Unit, if error persists, Return for Service
007
x
Inflator 1 error Restart Unit, if error persists, Return for Service
008
x
Left Sensor Error Return for Service
009
x
Right Sensor Error Return for Service
010
x
Central Sensor Error Return for Service
011
x
Gyro Sensor Error Return for Service
012
x
Squib Arming Error Restart Unit, Recharge Battery, if error persists, Return Service
013
x
Synchronization Error Reflash Firmware / Return for Service
015 x Load Algorithm Error Reflash Firmware
018
x
Inflator 2 Error Restart Unit, if error persists, Return for Service
019 x Left Sensor Power Supply Return for Service
020
x
Right Sensor Power Supply Return for Service
024 x Algorithm Not Stable Switch system off and on, sitting on motorcycle
025 x Unit Locked
Indicates that both charges have been fired
and that the airbag must be replaced.
128 First Charge Activated No action.
136 Second Charge Activated Return for service / Dispose of System.
27 EN
RACE