Allot NetEnforcer AC-1000 Series, Hardware Manual

Page: 61 / 97

Chapter 3: Setting Up the NetEnforcer
NetEnforcer AC-1000 Hardware Guide 3-15
Select whether you have a gateway defined in your network. If you select N then
you will exit to the next step, skipping step 2-4. If you have a gateway select Y and
proceed:
2-4.Gateway:
xxx.xxx.xxx.xxx
(the current gateway definitions are displayed)
8.
Specify the IP address of the default gateway. Use the up and down arrow buttons to
select the required number and the left and right arrow buttons to move between the
digits.
9.
Press the
Enter
button. The display area indicates the following:
[S]ave/[C]ancel
10.
Use the arrow buttons to select whether to save the settings or cancel and press the
Enter
button. The new IP and gateway settings are applied and after a few
moments, the display area displays its default view, the current bandwidth
consumption.
The following cases of failure may be indicated:
Failure Display
Register NIC Settings
Fail: NE IP save
Chk NE IP config
Netmask Save
Fail: MASK save
Chk NE IP config
Management NIC Save
Fail: Mgmt save
Chk NE IP config
Gateway Save
Fail: GW save
Chk NE IP config