Allot NetEnforcer AC-1000 Series, Hardware Manual

Page: 60 / 97

Chapter 3: Setting Up the NetEnforcer
NetEnforcer AC-1000 Hardware Guide
3-14
[100]/[10] Mbps
5.
Use the arrow buttons to select the link speed of the selected interface and press the
Enter
button. The display area indicates the following:
[S]ave/[C]ancel
6.
Use the arrow buttons to select whether to save the settings or cancel and press the
Enter
button. The new NIC settings are applied and after a few moments, the
display area displays its default view, the current bandwidth consumption.
Setting the NetEnforcer IP Address
Setting the NetEnforcer IP address enables you to specify the IP address, netmask and
default gateway for NetEnforcer.
To configure the IP address:
1.
With the display area displaying the default view, press the Select button. The Main
menu is displayed.
2.
Press the down arrow once to display the following:
Main menu:
2. Setup IP
3.
Press the
Select
button. The display area indicates the following:
2-1.Set IP:
xxx.xxx.xxx.xxx
(the current IP address definitions are displayed)
4.
Specify the IP address of NetEnforcer. Use the up and down arrow buttons to select
the required number and the left and right arrow buttons to move between the digits.
5.
Press the Enter button. The display area indicates the following:
2-2.Set mask:
xxx.xxx.xxx.xxx
(the current netmask definitions are displayed)
6.
Specify the netmask of NetEnforcer. Use the up and down arrow buttons to select
the required number and the left and right arrow buttons to move between the digits.
7.
Press the
Enter
button. The display area indicates the following:
2-3 Gateway exists [Yes/No]