Allot NetEnforcer AC-1000 Series, Hardware Manual

Page: 17 / 97

Chapter 1: AC-1000 Series Hardware
NetEnforcer AC-1000 Hardware Guide 1-7
Unit Status Indicators
The modes of operation of the Standby, Active and Power LEDs on the LCD panel are
described in the table below.
Indicator Status NetEnforcer Status
Standby
On Two NetEnforcers are connected in Parallel Redundancy
mode and this NetEnforcer is the secondary system.
Off This NetEnforcer is the primary system. If you have one
NetEnforcer, this should be the normal state of the LED. If
you have two NetEnforcers configured in Parallel
Redundancy mode, this NetEnforcer is the primary system.
Active
On NetEnforcer is in Active mode.
Off NetEnforcer is in Bypass mode, or this is the secondary
NetEnforcer in a Parallel Redundancy configuration and it
is not active. Traffic passes through NetEnforcer with no
Quality of Service or traffic shaping.
Power
On NetEnforcer is powered up.
Off NetEnforcer is shut down.
Table 1-1 – Standby/Active/Power LED Conditions