Allot NetEnforcer AC-1000 Series, Hardware Manual

Page: 42 / 97

Chapter 1: AC-1000 Series Hardware
NetEnforcer AC-1000 Hardware Guide
1-32
Connect to a reliably grounded SELV source. Grounding is achieved through
connection of the power entry module grounding terminal to one power port of the
terminal block by min. No. 14 AWG green/yellow conductor.
This equipment shall be connected directly to the DC supply system grounding
electrode conductor or to a bonding jumper from grounding terminal bar or bus to
which the DC supply system grounding electrode is connected. When connecting the
supply wires to the DC main supply, the earth conductor will be connected first and
disconnected last.
This equipment shall be located in the same immediate area (such as, adjacent cabinets
or any other equipment that has a connection between the grounded conductor of the
same DC supply circuit and the grounding conductor, and also the point of grounding of
the DC system. The DC system shall not be grounded elsewhere.
Powering Up Via LCD Panel
NOTE The NetEnforcer and the Bypass Unit have to be fully plugged and
connected before power is turned on. This is to ensure proper and
systematic power up.
It is recommended to connect the two power line feeds to separate power sources to
have full power redundancy. The two bi-color
Power
LEDs on the rear of NetEnforcer
are lit indicating that the power supply is connected to power and no failure condition
exists.
The
Power
LED on the LCD panel is lit and the
Mode
LED on the Bypass Unit is off,
indicating that the power is on and NetEnforcer is bypassed.
The display area of the LCD panel indicates the following:
Power On
.
After a few seconds, the display area of the LCD panel indicates the following:
System Loading * .
Once the system has completed loading, the following occurs:
The
Active
LED on the LCD panel is lit and the
Mode
LED on the Bypass Unit is lit,
meaning that NetEnforcer is now connected to the network.