Allot NetEnforcer AC-1000 Series, Hardware Manual

Page: 49 / 97

Chapter 3: Setting Up the NetEnforcer
NetEnforcer AC-1000 Hardware Guide 3-3
To connect to a NetEnforcer via Telnet:
1. Open a Microsoft DOS window on a PC and at the C:\ prompt, enter
Telnet
(IP address of NetEnforcer). Press <
Enter
>. The system boots
up and you are prompted for a login and a password.
2. Enter
admin
for the login and
allot
for the password. (To change the
password, see page 3-9.)
Press
<Enter>
. The NetEnforcer Setup Menu is displayed:
NetEnforcer Start Menu
From this menu, you can perform the following tasks:
•
Display the current configuration, page 3-4.
•
Configure network parameters, page 3-6.
•
Change the login password, page 3-9.
•
Modify the date and time settings, page 3-10.
•
Reboot and Shutdown the unit, p 3-16.