Allot NetEnforcer AC-1000 Series, Hardware Manual

Page: 57 / 97

Chapter 3: Setting Up the NetEnforcer
NetEnforcer AC-1000 Hardware Guide 3-11
•
Press
<Enter>
to set the time.
Changing the Root User Password
You can change the root password that provides access to super-user rights.
To change the root password:
1. Use the supplied serial cable to connect the terminal to the Console Connector on
the front panel of NetEnforcer.
2. Set the NetEnforcer power switch, located near the NetEnforcer power cable, to the
ON position. The system boots up and on the terminal you are prompted for a login
and a password.
3. At the terminal, press <Enter>. The system boots up and you are prompted for a
login and a password.
4. Enter
root
for the login and
bagabu
for the password, and then press <Enter>.
5. Enter passwd and then press <Enter>.
6. Enter a new password and press <Enter>. The password must be between 5 and 8
characters. You can use a combination of upper and lower case letters and
numbers.
7. Re-enter the new password and press <Enter>.
When all necessary parameters are set, NetEnforcer prompts you to reboot. After
rebooting is completed, NetEnforcer is ready to be connected and to add Quality of
Service in your network.
TIP You can further protect access to the NetEnforcer by limiting the hosts that
are allowed to manage the unit.