14-6
SERVICING
SM CKDDCI 2-A.3 GB
14.1.13 Removing main board
14.1.13.1 GC 36-43-60 DCI
1. Remove the service front panel according
to
14.1.1
.
2. Check to ensure that LEDs and display
board are OFF.
3. Disconnect all connectors from the main
board.
4. Squeeze the 8 spacers head with Long-
Nose Pliers and pull out the board.
Note:
It might be easier to remove the main
board panel first and than pull out the board
from its spacers
.
Notes for re-assemble the main board:
1. Make sure to correct all the connectors
into the connect locations. If incorrectly
connected, malfunction or damage to the
electrical parts may occur.
2. Hold the wires to the cable holders.
3. Ensure to set all the dip switches to the
same configuration as the original.
Removing main board Panel
14.1.13.2 GCD 036 DCR
1. Remove the service front panel according to
14.1.1
2. Remove the controller cover by taking out the screw
and lift upwards.
3. Check to ensure that LEDs and display board are
OFF.
4. Disconnect all connectors from the main board.
5. Squeeze the 8 spacers head with Long-Nose Pliers
and pull out the board.
Note:
It might be easier to remove the main board panel
first and than pull out the board from its spacers.
Notes for re-assemble the main board:
1. Make sure to connect all the connectors into the right
locations. If incorrectly connected, malfunction or
damage to the electrical parts may occur.
2. Hold the wires to the cable holders.
Ensure to set all the dip switches to the same configuration
as the original.
Removing main board Panel
