14-5
SERVICING
SM CKDDCI 2-A.3 GB
Removing Compressor Insulation
Removing Compressor
14.1.11
Removing Tubing Thermistors
1. Remove the service front panel according to
14.1.1
.
2. Remove the side and top panels according to
14.1.2
,
14.1.3
3. Check to ensure that LEDs and display board are
OFF.
4. Disconnect the thermistor connector from the main
board.
5. Remove the thermistor wires from the cable holders
along the electronics box.
6. Cut the nylon ties holding the wires to the pipes.
7. Pull up the spring from the housing while pulling the
thermistor.
Notes for re-assemble the thermistor:
1. Make sure the spring is inserted first and is facing the
tube to be attched to.
2. hold the thermistor wires to the tube with nylon tie
holding both the wires and the protective sleeve.
14.1.12 Removing Outdoor Air Thermistor
1. Remove the service front panel according to
14.1.1
.
2. Remove the top panel according to
14.1.2
.
3. Check to ensure that LEDs and display board are
OFF.
4. Disconnect the thermistor connector from the main
board.
5. Remove the thermistor wires from the cable holders
along the electronics box and the fan motor assembly.
6. Cut the nylon ties holding the wires to the metal
chassis.
Removing Thermistors
Disconnect
