14-9
SERVICING
SM CKDDCI 2-A.3 GB
14.1.15.2
GC 60 DCI
Remove the electrical assembly according to
3.
14.1.14
.
Remove the three (4) screws fixing the main board panel
4.
to the assembly and take the panel out.
Remove the earth tab connection from the line filter.
5.
Remove the five (5) screws fixing the terminal panel to
6.
the assembly and take the panel out.
Disconnect all the wires from the driver terminals and the
7.
communication connector.
Remove the five (5) screws fixing the back panel to the
8.
driver panel and take the panel out.
Remove the four (2) screws fixing the driver module to
9.
the heatsink.
Squeeze the 4 spacers head with Long-Nose Pliers and
10.
pull out the board.
Wipe out the grease paste with cloth soaked with
11.
alcohol.
Notes:
Do not hold the PCB part of the driver module when
removing the driver module.
When handling the module, take care of not to use
excessive force as this may cause damage.
14.1.15.3 GCD 036 DCR
Remove the electrical assembly according to
1.
14.1.14.2.
Remove the three (3) screws fixing the main board
2.
panel to the assembly and take the panel out.
Remove the two (2) screws fixing the terminal panel to
3.
the assembly and take the panel out.
Remove the four (4) screws holding the heat sink cover
4.
to the heat sink.
Removing driver module
Removing driver module
