14-8
SERVICING
SM CKDDCI 2-A.3 GB
14.1.14.2 GCD 036 DCR
Remove the service front panel according to
1.
14.1.1
.
Remove the side and top panels according to
2.
14.1.2
.
Check to ensure that LEDs and display board are
3.
OFF.
Disconnect the connectors from the main board.
4.
Disconnect the compressor cable connector.
5.
Remove the chock coils wires from the chock terminal
6.
block.
Remove the three (3) screws fixing the electrical box to
7.
the controller support plate, and the side panel.
Pull the box left and than up.
8.
Notes for re-assemble the Electrical assembly:
Make sure to connect all the connectors into the right
1.
locations. If incorrectly connected, malfunction or
damage to the electrical parts may occur.
Hold the wires to the cable holders
2.
14.1.15 Removing driver module
14.1.15.1 GC 36-45 DCI
1. Remove the electrical assembly according to
14.1.14
.
2. Remove the three (3) screws fixing the main board panel
to the assembly and take the panel out.
3. Remove the earth tab connection from the line filter.
4. Remove the five (5) screws fixing the terminal panel to
the assembly and take the panel out.
5. Disconnect all the wires from the driver terminals and the
communication connector.
6. Remove the five (5) screws fixing the line filter panel to
the driver panel and take the panel out.
7. Remove the four (4) screws fixing the driver module to
the heatsink
.
8. Wipe out the grease paste with cloth soaked with
alcohol.
Notes:
Do not hold the PCB part of the driver module when
removing the driver module.
When handling the module, take care of not to use
excessive force as this may cause damage.
Removing driver module
Removing Front Panel
