Agilent Technologies Agilent E5250A, User Manual

Page: 25 / 326

Agilent E5250A User’s Guide, Edition 11 1-9
Introduction
Agilent E5255A Product Description
Resistors Resistors connected between BIAS path and IV path are for
protecting DUT from electrical damage. When shipped from
factory, 0
Ω
resistance is used in the E5255A. You can easily
replace with desired resistors. Refer to Chapter 2. The
following resistors are furnished with the E5255A:
• 0
Ω
resistors (3 sets with 10 resistors in each set)
• 1.2 k
Ω
resistors (3 sets with 10 resistors in each set)
• 22 k
Ω
resistors (3 sets with 10 resistors in each set)
If you replace initial 0
Ω
resistors with other resistors, you must
cut the initial resistors. Then, if you need 0
Ω
resistors again,
use the ones listed above.
WARNING Be careful about the following when selecting protective resistors:
• If only one E5255A is installed in the mainframe, total power consumption
by resistors must be less than 16W.
• If multiple E5255As are installed in the mainframe, total power
consumption by resistors must be less than 32W.
• Consider the current flows to resistor when DUT shorts, and make sure the
power consumption by resistor will be within specification of resistor.
Do not use resistors that have specifications inadequate for your
applications, which will result in resistors heating up, burning, or smoking.
Be careful about the heating of the rear panel of mainframe or plug-in card,
which may be heated by resistors, even if you follow this warning.