Agilent Technologies 34970A, Service Manual, Page: 57 / 273

To Read the Relay Cycle Count
The instrument has a Relay Maintenance System to help you predict
relay end-of-life. The instrument counts the cycles on each relay in the
instrument and stores the total count in non-volatile memory on each
switch module. You can use this feature on any of the relay modules and
the internal
DMM
.
• In addition to the channel relays, you can also query the count on
backplane relays and bank relays. Note that you cannot control the
state of these relays from the front panel but you can query the count.
• You can also query the state of the three relays on the internal
DMM
.
These relays are numbered “1”, “2”, and “3” (which correspond to
relays K102, K103, and K104 respectively). These relays open or close
when a function or range is changed on a module.
• The 34908A multiplexer contains 40 channels which are switched
(
HI
only) using only 20 relays. Each relay is used to switch
HI
on two
different channels (and only one channel can be closed at a time).
The channels are arranged such that channels 01 and 21 use different
contacts on the same relay. The remaining channels are also paired in
the same manner (channels 02 and 22, channels 03 and 23, etc.).
Therefore, when you query the relay count on a channel, the number
reflects the number of times that the relay was closed. For example,
the relay count will always be the same on channels 01 and 21.
•
For more information on relay life and load considerations, refer to
“Relay Life and Preventative Maintenance” in the 34970A User’s Guide .
•
To read the count on the active channel, choose the following item
and then turn the knob. To read the count on the internal
DMM
relays, turn the knob counterclockwise beyond the lowest numbered
channel in the instrument. To read the “hidden” relays, turn the knob
clockwise beyond the highest numbered channel in the current slot.
RELAY CYCLES
3
Chapter 3 Front-Panel Overview
To Read the Relay Cycle Count
55