AFP Imaging Mini-Medical Series, Installation, Operation & Service Parts Manual

Page: 54 / 132

Operation
Mini Med Series
0000061122
Checklists for Daily Use
Startup
1. Check solution levels.
a) Top off processing tanks and fill wash tank.
2. Power Switch to ON, check drive gears for meshing;
allow 15-30 minutes warm up.
3. Clean feed tray, receiving bin.
4. Check developer activity, fixer pH.
Operation
1. Feed material, trip Film Feed switch to start processing cycle.
2. Wait until Wait light goes out or beeper sounds before opening film feed tray.
Shutdown and Daily Cleaning
1. Switch off power.
2. Drain and rinse wash tank, close valve.
3. Clean:
a) roller surfaces, rack and tank area
b) splashes from inside top cover.
4. Wipe outside surfaces of the processor, inside surfaces of feed tray & cover box
and both side panels.
5. Leave top cover slightly open to prevent condensation.
NOTE: Duplicate these checklists and post them near the processor.
3-8