AFP Imaging Mini-Medical Series, Installation, Operation & Service Parts Manual

Page: 47 / 132

Operation
Mini Med Series 0000061122
NOTE: For operator convenience, the
LED Display Panel and the Power Switch
Panel may be switched, right to left,
during installation of the processor.
See Page 2-8 for details.
Figure 3-1, User Controls
Controls and Indicators
All of the user controls and indicators for operation of Mini-Medical Processors are
located on the front of the processor. These controls are described below and on the
following page.
User Controls
1. Power Switch
OFF All power to processor is OFF.
ON Processor is ON, (runs one approximate 5 minute process cycle initially),
then reverts to standby mode. Circulation pumps, developer heater and air
circulation fan are ON. Transport, replenishment system and dryer will
operate when Film Feed switch is activated. Power On lamp will light.
CENTER This switch also serves as the circuit breaker for the processor. If tripped to
the center position reset to OFF, then turn ON. If the switch trips again, the
processor probably needs a service call. Do not use the processor if it trips
off repeatedly.
1
2
4
8
7
3
9
6
5
3-1