AFP Imaging Mini-Medical Series, Installation, Operation & Service Parts Manual

Page: 38 / 132

Installation
Mini Med Series 0000061122
Control Panel Positioning
In some installations, such as with the right side of the processor against a wall, it may be
difficult for the processor operator to view the LED’s on the Display Panel to the left of the
feed tray.
If this is the case, to make the LED Display Panel more visible, use the following procedure
to reverse the positions of the Power Switch/Circuit Breaker and the LED Display Panel.
1) Disconnect the processor power cable from its outlet.
2) Remove the two screws holding the control chassis panel to the front of the processor.
Carefully lower the panel until it is supported by its restraining straps.
3) Locate the small screw(s) that holds the LED Display Panel and the Power Switch panel
in place. Remove the screws.
4) Carefully unlace the cables for each panel from the retaining clips back as far as the
center of the loom.
5) Re-install the panels in the desired position,taking care to replace the cables through the
retaining clips.
6) Replace the panel securing screws and close the control chassis and secure it with its two
screws.
7) Return the processor to service.
2-8