EKI-6333AC-4GP User Manual
40
When
By User Policy
is selected, a
User Policy List
screen appears. With properly
configured your policy rules, system will route traffics through available WAN
interface based on user defined rules.
Figure 3.34 Basic Network > WAN & Uplink > Load Balance
When
Add
button is applied, the
User Policy Configuration
appears.
Figure 3.35 Basic Network > WAN & Uplink > Load Balance > User Policy
Configuration
The following table describes the items in the previous figure.
Item
Description
Source IP Address
There are four options can be selected:
Any:
No specific Source IP is provided. The traffic may come
from any source.
Subnet:
Specify the Subnet for the traffics come from the
subnet. Input format is: xxx.xxx.xxx.xxx/xx e.g.
192.168.123.0/24.
IP Range:
Specify the IP Range for the traffics come from the
IPs.
Single IP:
Specify a unique IP Address for the traffics come
from the IP. Input format is: xxx.xxx.xxx.xxx e.g.
192.168.123.101.
Destination IP Address
There are five options can be selected:
Any:
No specific destination IP is provided. The traffic may
come to any destination.
Subnet:
Specify the Subnet for the traffics come to the
subnet. Input format is: xxx.xxx.xxx.xxx/xx e.g.
192.168.123.0/24.
IP Range:
Specify the IP Range for the traffics come to the
IPs.
Single IP:
Specify a unique IP Address for the traffics come
to the IP. Input format is: xxx.xxx.xxx.xxx e.g.
192.168.123.101.
Domain Name:
Specify the domain name for the traffics
come to the domain.
Destination Port
There are four options can be selected:
All:
No specific destination port is provided.
Port Range:
Specify the Destination Port Range for the
traffics.
Single Port:
Specify a unique destination Port for the traffics.
Well-known Applications:
Select the service port of well-
known application defined in drop-down menu.
Protocol
There are three options can be selected. They are
Both
,
TCP
, and
UDP
.
WAN Interface
User can select the interface that traffic should go.
Note that the WAN interface drop-down menu will only show the
available WAN interfaces.
