EKI-6333AC-4GP User Manual
114
Auto Upgrade via HTTP(S)/FTP(S) source can be configured in the bottom part. If
the Firmware or Configuration found on the server is newer than the current one, it
will be updated.
Figure 3.164 Administration > System Operation > Backup & Restore > Auto
Upgrade
The following table describes the items in the previous figure.
Item
Description
Enable
Enable
Firmware
or
Configuration
upgrade or both:
Firmware:
The router will look for a newer firmware file and
update when found.
Config:
The device check for a configuration update by
comparing the file dates and installs it using this setting.
config .ver example
button will prompt the download of .ver file
example needed on server for Config update.
Source
Select the location of the upgrade files:
HTTP(S) / FTP(S):
Updates are downloaded from the Base
URL address below. Used protocol is specified by the
address: HTTP, HTTPS, FTP or FTPS.
Base URL
IP address from which the configuration file will be downloaded.
This option also specifies the communication protocol, example:
http://example.com
Unit ID
Name of configuration file (name of the file without extension). If
not filled, the MAC address of the router is used as the filename
(the dots are used as delimiter instead of colons.)
Update Hour
Set the time (range 24 to 720 hours) to regularly check for
updates.
If the
Auto update after turning on the router
checkbox is
enabled, the check is performed five minutes after the device is
powered up or rebooted. If the detected firmware or configuration
file is newer than the running one, it is downloaded and the router
is rebooted automatically.
Save
Click
Save
to save the settings.
Undo
Click
Undo
to cancel the settings.
